The test systems in our environmental simulation laboratory are designed for normative and customer-specific test requirements. The know-how of our test engineers is based on years of professional experience in handling your products from a wide variety of areas. This is the basis for the implementation and testing of your current and future product requirements.

Climatic tests in the range of - 50 ° C up to 180 ° C, with or without humidity option, with a test room volume of 0.5 m³ up to 24 m³ and vibration tests up to a total weight of max. 2t, e.g. Control cabinets, air conditioning units or printers are marginal values of our possibilities.


Accreditations: DIN EN ISO/IEC 17025:2018
Certifications: DIN EN ISO 9001:2015 and DIN EN ISO 14001:2015

Typical Standards for the applications listed above

Mechanical tests

  • DIN EN 60068-2-6 (oscillation, sinusoidal)
  • DIN EN 60068-2-27 (shock)
  • DIN EN 60068-2-64 (oscillation, noise-like)
  • DIN EN 60068-2-53 (combined climatic (temperature / humidity) and
    dynamic (vibration / shock) tests

Temperature tests

  • DIN EN 60068-2-1 / -2 (cold / dry heat)
  • DIN EN 60068-2-14 (temperature change)

Climatic tests

  • DIN EN 60068-2-30 (damp heat, cyclical)
  • DIN EN 60068-2-38 (temperature / humidity, cyclical)
  • DIN EN 60068-2-74 (damp heat, constant)

Corrosion tests

  • DIN EN 60068-2-11 (salt fog)
  • DIN EN 60068-2-52 (salt spray, cyclical)
  • DIN EN 60068-2-60 (mixed / harmful gas)

Protection classes (IP code)

  • DIN EN 60529 (degrees of protection through housing)
  • ISO 20653 (road vehicles - degrees of protection)
Environmental simulation laboratory equipment

  • Temperature and humidity cabinets up to 24 m³
  • Air pressure chamber with negative pressure up to 200 mbar
  • Electrodynamic vibration test systems up to 300kN (option: with temperature / humidity overlay)
  • IP water test equipment (dropping, splashing, immersion)
  • Salt fog chambers up to 11 m³
  • Flammability test facility

Monitoring systems

  • For controlling and monitoring of test samples e.g. resistance-monitoring by micro-cut, automatic button-pushing systems, electrical charging & loading systems
  • Standardized measurement procedures for recording analog measurements
  • Automatic optical monitoring systems
  • Monitoring of digital signals e.g. CAN, LIN, Ethernet, RS232
  • Simulator of GPS signal

Your contact 
Simon Held B.Sc.
Section Manager Sales Environmental Simulation
Normen Klatt
Project Engineer Environmental Simulations
Klaus Lohre
Sales EMC Automotive